The conspicuity treatment is not required to be continuous. Each strip of retro reflective sheeting must be positioned as horizontally as practicable, beginning and ending as close to the front and rear as practicable. The 2″ DOT C2 retro reflective sheeting need to be applied to both sides of the trailer or semitrailer. Locations For DOT Reflective Tape Conspicuity TreatmentĪpplying Reflective Safety Tape to the Sides Of The Trailer Trucks must be marked with reflector tape in a similar fashion. At the back of the vehicle, two continuous strips must be used in the lower rear and two inverted L shapes of solid white must mark the top corners of the trailer.
#REFLECTOR 2 CRASHES INSTALL#
The NHTSA ruling allows trailer manufacturers to install either red and white retro reflective tape or sheeting or reflex reflectors. Is Trailer Reflective Tape Always Required? On December 10, 1992, the National Highway Traffic Safety Administration or NHTSA published a final rule requiring that trailers manufactured on or after December 1, 1993, which have an overall width of 80 inches or more and a gross vehicle weight rating (GVWR) of more than 10,000 pounds, (with the exception of pole trailers and trailers designed exclusively for living or office use) be equipped on the sides and rear with a means for making them more visible on the road. These requirements were set up by the FMCSA to help improve visibility in low light conditions and help reduce potentially fatal motor vehicle crashes into the sides or back of stopped or parked trucks and tractor trailers at night or in poor visibility.